Check material and reference state first
This table supplements the periodic table with compounds and composite materials. Ethanol denotes the pure substance; denatured alcohol and drinks have different compositions. Window glass and oak are material groups. A measured density outside a classroom guide therefore does not alone prove adulteration or measurement error.[1]
Almost all rows refer to 25 °C; ice explicitly refers to 0 °C. The broad label “water” is therefore insufficient: ice and liquid water have different volumes at the same mass. The source section specifies no precise pressure for these solid and liquid data, so none is invented or copied from gas conditions.[1]
Mass, volume and compatible units
For a uniformly composed object, or as a mean density over the specified volume.[2]
Both mass and volume conversion factors must be applied.
One millilitre equals one cubic centimetre exactly, so g/cm3 and g/mL represent the same density unit. Litres and cubic metres are different: 1 L = 10−3 m3. Multiply a density in g/cm3 by volume in cm3 to get grams, then convert the mass to kilograms if needed.[2]
The density formula connects mass, volume and units. For floating objects, buoyancy adds the force balance.
A range is not an exact material constant
Window glass is listed as 2.4–2.6 g/cm3. Treating volume as specified, multiplying by both bounds gives a mass range. This is a material guide range, not a statistically determined 95% confidence interval. A real measurement also carries volume uncertainty.[1]
The oak entry applies to air-dry wood. Moisture, pores and specimen structure affect material properties. Mean density depends on which volume, including pores, was measured. Without that definition, one precise-looking number would be less useful than the explicit guide range.[1]
Two calculations respecting state and range
Mass of an ethanol volume
- Given
- 250 mL pure ethanol at 25 °C; reference density ρ ≈ 0.79 g/cm3.
- Find
- Estimate mass while respecting limited precision.
Write volume in a unit compatible with density.
Multiply symbolically by density.
Result: Arithmetic intermediate value 197.5 g; as a rough estimate, about 0.20 kg. The rounded density does not support tenth-of-a-gram accuracy.
Check: The mass is below that of the same water volume. The cm3 units cancel completely.
A glass block with a density range
- Given
- A window-glass block has an assumed volume of 40 cm3. Density guide range: 2.4–2.6 g/cm3.
- Find
- Determine a mass range from the material range.
Multiply each density bound by the same volume.
Keep the interval instead of silently treating its midpoint as exact.
Result: The table suggests approximately 96–104 g, treating the specified volume as fixed.
Check: The midpoint would be 100 g but does not replace the material range. Volume measurement uncertainty is not included.
Equal volumes, different masses
Density is the slope of m(V)
Five exercises on lookup values and units
Calculate · Application
A sample has m = 118.5 g and V = 150 cm3. Find its mean density.
Show hint
Divide mass by volume and retain the quotient unit.
Learning goal: Calculate density and distinguish a match from identification.
Show solution and calculation
ρ = 118.5/150 = 0.79 g/cm3.
This matches the rounded ethanol guide but does not identify the substance uniquely.
Rearrange · Application
What volume estimate corresponds to 315 g glycerol at ρ ≈ 1.26 g/cm3?
Show hint
Rearrange the density equation for V.
Learning goal: Derive volume from mass and density.
Show solution and calculation
V = m/ρ ≈ 315/1.26 = 250 cm3 = 250 mL.
It remains an approximation for the stated conditions.
Calculate · Application
Convert 2.3 g/cm3 to kg/m3.
Show hint
One g/cm3 equals 1000 kg/m3.
Learning goal: Convert mass and cubic-volume units together.
Show solution and calculation
2.3 · 1000 = 2300 kg/m3.
Converting only grams while leaving cm3 unchanged gives the wrong factor.
Error analysis · Application
Someone uses the liquid-water value 1.00 g/cm3 for 100 cm3 of ice. Why is this an unsuitable table lookup?
Show hint
Compare phase and temperature in the two rows.
Learning goal: Treat phase as part of a lookup value.
Show solution and calculation
Liquid water and ice are different reference states.
Using the ice guide at 0 °C gives m ≈ 0.917 · 100 = 91.7 g rather than 100 g.
Transfer · Application
A uniform oak block has ρ = 0.75 g/cm3. What floating tendency follows in water at ρ ≈ 1.00 g/cm3 in the simple model? Neglect water absorption.
Show hint
Compare mean object density with liquid density.
Learning goal: Connect density values to a bounded buoyancy model.
Show solution and calculation
Because the block’s density is lower, it can float partly immersed.
The idealised equilibrium immersed-volume fraction is about 0.75/1.00 = 75%, under the stated assumptions.
Common density-table questions
Are g/cm3 and kg/m3 interchangeable? They describe the same quantity, but numerical values differ by a factor of 1000.
Why does glass have a range? Composition and manufacturing vary. The interval describes a material group, not an exact constant.
Is water density exactly 1? No. Density depends on state, temperature and pressure. Here, 1.00 g/cm3 is a rounded classroom value at 25 °C.
Can gas densities be added directly? Only with pressure and temperature. This selection avoids mixing gas values at 0 °C with liquid values at 25 °C.
Does matching density prove a substance’s identity? No. Different substances and mixtures can have similar densities. Identification needs additional properties or analysis.
Sources for this explanation
Quanta · Updated November 7, 2026
- IQB/KMK: Mathematisch-naturwissenschaftliche Formelsammlung, Stand 04.07.2023, S. 53
- OpenStax University Physics Volume 1, §14.1: Fluids, Density, and Pressure
Editorial responsibility: Quanta Study editorial team
Review scope
This explanation, 2 worked examples and 5 exercises are available in German and English. Structure, source references and mathematical notation undergo automated checks. Calculations, model assumptions and both language versions receive a separate AI review.
An independent, named human subject review has not yet been documented. Our exercise numbers are worked examples, rather than measurements published by the cited sources.
Editorial responsibility, sources and methodsChange history
- Explained comparative compound and material densities, temperatures, ranges, two examples and five exercises.
Cite this reference page
Quanta. Density of selected substances and materials. Updated November 7, 2026. https://quanta-study.de/en/formula-sheet/tables/stoffdichten
When citing a specific scientific statement, also cite the specialist source linked to that statement.
